This standard is issued under the fixed designation A /A M; the 1 This specification is under the jurisdiction of ASTM Committee A ASTM A/AM: Standard Specification for Steel, Sheet and Strip, Heavy- Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural. Find the most up-to-date version of ASTM A at Engineering
|Published (Last):||7 July 2006|
|PDF File Size:||15.64 Mb|
|ePub File Size:||8.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard.
ASTM A635 Grade 1018
This specification covers the general requirements for hot-rolled, heavy-thickness, and high-strength low-alloy with improved formability sheet and strip coils.
These coils are normally produced from rimmed, capped, or semi-killed steel.
Steels may be produced as ingot-cast or strand-cast. Cast or heat analysis shall be made to determine the conformance with the requirements.
For steels other than non-killed capped or rimmedproduct analysis may be made. The chemical analysis shall conform to the specified amounts of carbon, manganese, phosphorus, sulfur, silicon, and copper.
Steels may or may not be subjected to tension test requirement. Specimen preparation and test methods are discussed. The mechanical property requirements, number of specimens, test locations, and specimen orientation shall be in accordance with the applicable product specification. Tolerances for the dimensions of sheet and strip coils are specified.
Astj abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express atsm implied or make any representation that the contents of this abstract are accurate, complete or up to date. The purchaser is advised to discuss this change with the supplier.
AK Steel ASTM A and A Hot Rolled Carbon Steel, Structural Steel (SS)
The values listed asym not exact conversions of the values listed in the inch-pound tables, but instead are rounded or rationalized values. The term weight is used when inch-pound units are the standard.
However, under SI, the preferred term is mass. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Combining values from the two systems may result in non-conformance with the standard.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Hot-rolled heavy thickness coils 12 in.
Size Limits, Coils Only. All Widths A All Widths. Link to Active This link will always route to the current Active version of the standard.